P421 P2P FTTH Optical Home Gateway

P2P FTTH Optical Home Gateway

Introduction

   FOT P421 series is P2P FTTH Optical home gateway, which provider Gigabit Ethernet, VoIP and CATV service for the triple play market.

   This FTTH P2P CPE is with single and dual fiber structure design to satisfy project needs. Fiber tray is optional. FOT P421 P2P FTTH Optical Home Gateway

Features

  • 10/100/1000Mbps fiber optical uplink, single or dual fiber are optional.
  • IEEE802.1p priority, support four priority queues
  • IEEE802.1Q VLAN
  • TCP/IP IPv4+IPv6*, DHCP, RTP, RTCP, HTTP, TFTP,FTP, PPPoE*, NTP*
  • IGMP(V1, V2, V3 (future)) snooping
  • CATV input: -8 to +2 dBm, RF output: 80dBuV @ -8 to +2 dBm, support level monitoring (SNMP MIB, web interface, CLI) and SNMP trap reporting
  • CATV receiver status can be monitored and controlled by management software
  • RFC 3261 SIP: Session Initiation Protocol
  • Codec: G.711 A-law and μ-law codec,G.729 (A, B, AB)
  • DMTF: In-band DTMF, RFC 2833, SIP-info
  • Wireless:IEEE802.11b/g/n
  • Wireless Security (Encryption):WPA2-Enterprise, WPA2-PSK, WPA-Enterprise, WPA-PSK, WEP Open

Specifications

ItemParameters
ModelP421: GE optical uplink+4GE LAN+2FXS+CATV
P421W: GE optical uplink+4GE LAN+2FXS+CATV+WiFi
PortsUplink: 10/100/1000Mbps, single fiber, SC/APC,
LAN port: 4*10/100/1000Mbps, full/half duplex with auto-negotiation, auto MDI/MDIX, RJ45 connector
2*FXS port, RJ11 connector
1*CATV port, SCTE F type connector
Ethernet StandardIEEE802.3x flow control
LAN ports:
IEEE802.3 10Base-TX Ethernet
IEEE802.3u 100Base-TX Fast Ethernet
IEEE802.3ab 1000Base-TX GE
WAN ports:
IEEE802.3u 100Base-FX optical Ethernet for P1600
IEEE802.3z 1000Base-BX, 1000Base-LX for P1601
PriorityIEEE802.1p priority, support four priority queues
Support DiffServ
VLANIEEE802.1Q VLAN
ProtocolsTCP/IP IPv4+IPv6*, DHCP, RTP, RTCP, HTTP, TFTP,FTP, PPPoE*, NTP*
IGMPIGMP(V1, V2) snooping
Optical BIDI TransceiverData TX operating wavelength: 1310nm (1261 .. 1360nm)
Data TX output: > - 14dBm
Data RX operating wavelength: 1490nm (1480..1500 nm)
Optical RX sensitivity: < -30dBm
Range: 20 km on single-mode Fiber
Bit rate: 125Mbps for P1600, 1250Mbps for P1601
Standard Compliance: IEEE802.3u 100Base-FX for P1600, IEEE802.3z 1000Base-BX/LX for P1601
CATV PerformanceCATV input: -8 to +2 dBm
CATV input monitoring: Support level monitoring (SNMP MIB, web interface, CLI) and SNMP trap reporting
CATV function control: ON/OFF by microcontroller (DATA/CATV management)
CATV wavelength: 1550 +/- 5 nm
RF output: 80dBuV @ -8 to +2 dBm
RF frequency: 45 – 1000MHz (guaranteed performance up to
875MHz)
RF flatness: Typical +/- 1dB, Max +/-1.5
RF Return Loss: > 14Db
Optical isolation for CATV and Data: > 30dB
Receiver noise current: 4,0 pA/√Hz
RF connector: SCTE F type
CNR: > 48 dB
CSO: < - 55 dBc
CTB: < -61 dBc
VoIP performance
VoIP StandardRFC 3261 SIP: Session Initiation Protocol
RFC 2617 HTTP Authentication: Basic and Digest Access Authentication
RFC 2976 The SIP INFO Method
RFC 3263 Session Initiation Protocol (SIP): Locating SIP Servers
RFC 3264 An Offer/Answer Model with Session Description Protocol (SDP)
RFC 3515 The Session Initiation Protocol (SIP) Refer Method
RFC 3892 The Session Initiation Protocol (SIP) Referred-By Mechanism
Phone Functions Pulse Dial Detection
Hook Detection
Flash Detection
Polarity Reverse
Distinctive Ringing
Volume Adjustment
Codec G.711 A-law and μ-law codec
G.729 (A, B, AB)
Packetization Interval: 10, 20 and 30ms
DTMF In-band DTMF
RFC 2833
SIP-info
Class 5 services: Call forward unconditional
Call forward on busy
Call forward on no answer
Call hold / release
Call waiting
Caller ID (see below)
Caller ID Support (DTMF / FSK)
Voice QualityLine Echo Cancellation (LEC)
Adaptive jitter buffer
Packet Loss Concealment
Activity Detection
Comfortable Voice Generator
Gain Control
FaxModem/Fax support (T.38)
Pass-Through
DHCP option 66,67, supporting auto provisioning and associated DHCP option codes for TFTP config server
12: The DHCP Option 12 (Host Identifier)
DHCP client function DHCP client must continue to request an IP address at all times until it receives an IP address or unless the user has set the ATA into static IP mode
Signaling Tones Allow for configuration of custom signaling tones:
Frequency
Pitch
Pattern
Ring Cadence Allow configuration of ring parameters
Frequency
Voltage
Pattern/Cadence
ATA Isolation Ability to separate ATA into separate VLAN
Wireless performance
Wireless Standards IEEE802.11b/g/n
Wireless Security (Encryption) WPA2-Enterprise
WPA2-PSK
WPA-Enterprise
WPA-PSK
WEP
Open
QoS WMM-QoS (for multimedia applications)
Setup/ConfigurationWPS Support (Wifi Protected Setup)
Configuration File
Internal Web UI
TR069 (optional)
Power Supply12VDC
Power Consumption< 12.0W
Dimensions 265mm*195mm*43mm(L*W*H)
Net Wight0.7Kg
EnvironmentOperating Temperature :-10℃~50℃
Storage Temperature :-20℃~70℃
Operating Humidity :10%~90% non-condensing
Storage Humidity :5%~95% non-condensing

Application

FTTH P2P point to point Fiber Solution

FTTH P2P point to point Fiber Solution

Latest Blog

About Us

Why FTTH can save telecom cost

FTTH: saving money

【Our Goal】

Benefits our customers via Fiber Network (FTTH).

【FOT Telecom】

Your reliable fiber network equipment and service provider: Read More

Contact us

Email: sales@fiberoptictel.com fiberoptictelecom@gmail.com SKYPE: fanny-lee2007 SKYPE: fiberoptictelecom Tel: +86-20-6622 6784
Add.: Jitang Industrial Zone, No.8 Nanyun Five road, Huangpu, Guangzhou. 510663
ContactUs.com